Pilot Lighting Instructions

CAUTION: ALWAYS REMOVE YOUR FIREPLACE GLASS PRIOR TO LIGHTING YOUR PILOT

lighting_1

Locate gas supply valve (typically behind louvers, below glass opening – may be red or blue).

lighting_2
Open valve by pivoting handle to be parallel to gas line.


z
Locate pilot assembly with spark ignitor (located behind and below logs in the firebox – typically in the bottom center)
lighting_4
Then locate red or black ignitor button.* Push ignitor to verify spark at pilot area.


lighting_5
Locate the black or green valve control knob (knob
with the words “ON”, “OFF” and “PILOT” on it). Push in and rotate counter-clockwise until the word “pilot” is in the 6 o’clock position.**

lighting_6
While pressing and holding in the valve knob (in “PILOT” position – it should press in about 1/4″), press the red piezo button repeatedly (once per second) until the pilot ignites. If the pilot does not light, wait 5 minutes and try again. Once the pilot is lit, continue to hold the valve knob in for 30 seconds, then slowly release.


lighting_7
Locate gas supply valve (typically behind louvers, below glass opening – may be red or blue).

lighting_8
Finally, turn the unit’s ON/OFF switch (or wall switch or remote control) to the “ON” position to start your fire.

Make sure you put the glass front back on the fireplaceprior to burning your fireplace. Make sure the glass is securely clamped on, at all points, prior to replacing the front


intensity
Enjoy your fireplace!



 
* If you do not see a red or black spark ignitor button, you do not have a manual ignition system. If power is actively supplied to your fireplace, simply turn the on/off button, wall switch or remote control to “on” to ignite your main burner.
**Note: Some valve assemblies may be inverted in their brackets. If yours appears to be the mirror image of picture #4, then the word “PILOT” will be in the 12 o’clock position to light the pilot, and “ON” will be set to the 12 o’clock position to turn on your main burner.
CAUTION: ALWAYS REMOVE YOUR FIREPLACE GLASS PRIOR TO LIGHTING YOUR PILOT